Smart Plug
NXP offers a broad portfolio of wireless MCUs, to develop a smart plug that controls the energy supply of devices connected to it. Using a ZigBee™ interface this device connects to a gateway where you can send commands to turn on/off or see the power consumption of the device connected to it.
Faced with limited resources and booming demand, the energy industry seeks greater efficiencies within complex energy management and distribution processes, all while providing the best consumer experience.
Product Details
Supported Devices
Processors and Microcontrollers
KM Series Arm Cortex-M0+
- KM3x: 50–75 MHz Precision Metrology MCUs with Segment LCDs Based on Arm® Cortex®-M0+
- TWO-PHASE-POWER-METER: Two-Phase Power Meter Reference Design
Power Management
AC-DC Controllers with Integrated Power Switch
- TEA1723AT: HV Start-up Flyback Controller with Integrated MOSFET for 11 W Applications, F~Burst = 430 Hz
Integrated Switching Regulators
- PCA9410_9410A: 3.0 MHz, 500 MA, DC-to-DC Boost Converter
LED Drivers
- PCA9634: 8-Bit Fm+ I²C-Bus LED Driver
Wireless Connectivity
Zigbee
- JN5189_88_T: JN5189/88 (T): High-Performance and Ultra-Low-Power MCUs for Zigbee® and Thread with Built-In NFC Option
Analog and Mixed Signal
Real-Time Clocks
- PCA85073A: Automotive Tiny Real-Time Clock/Calendar with Alarm Function and I²C-Bus
Features
MCU
- High-performance Arm® Cortex®-M0 core, up to 75 MHz of core clock frequency
- 512 KB/256 KB/64 KB single array flash
- Supports v6-M Instruction Set Architecture (ISA) including all 16-bit v7-M instructions plus a number of 32-bit thumb-2 instructions
-
PLL to generate clocks for AFE
- Input range: 31.25 kHz to 39.0625 kHz
- Output range: 11.72 MHz to 14.65 MHz
- Flexible modes of operation
-
Two internal trim-able clock references
- 32 kHz
- 4 MHz
RF performance/power consumption
- NFC NTAG Option with EEPROM
- Quad-SPI for execute in place or data storage in NVM
- -100 dBm RX sensitivity
- up to 11 dBm TX power
- RX 4.3 mA, DC/DC on at 3V
- TX 7.4 mA @ 0 dBm, 20.3 mA @ 10 dBm
- 2.4 GHz IEEE 802.15.4 compliant
JN5189 Digital and Analog Interfaces
- UART/SPI/I²C up to 2
- ISO7816 Interface for Secure Access Module
- 8 ch 12-bit ADC
- 1 Analog comparator
- Digital Microphone Interface and Audio Event Detection
Documentation
Quick reference to our documentation types.
9 documents
-
Data Sheet
8-bit Fm+ I2C-bus LED driver
-
Data Sheet
3.0 MHz, 500 mA, DC-to-DC boost converter
-
Data Sheet
Kinetis KM35 Sub-Family Data Sheet