P89V660FBC: 8-bit 80C51 5 V low power 16 kB/32 kB/64 kB flash microcontroller with 512 B/1 kB/2 kB RAM, dual I2C-bus, SPI ARCHIVED

Principal features

• Dual 100 kHz byte-wide I²C-bus interfaces
• 128-byte page erase for efficient use of code memory as non-volatile data storage
• 0 MHz to 40 MHz operating frequency in 12x mode, 20 MHz in 6x mode
• 16 kB/32 kB/64 kB of on-chip flash user code memory with ISP and IAP
• 512 B/1 kB/2 kB RAM
• SPI (Serial Peripheral Interface) and enhanced UART
• PCA (Programmable Counter Array) with PWM and Capture/Compare functions
• Three 16-bit timers/counters
• Four 8-bit I/O ports, one 4-bit I/O port
• WatchDog Timer (WDT)

Additional features

• 30 ms page erase, 150 ms block erase
• Support for 6-clock (default) or 12-clock mode selection via ISP or parallel programmer
• PLCC44 and TQFP44 packages
• Ten interrupt sources with four priority levels
• Second DPTR register
• Low EMI mode (ALE inhibit)
• Power-down mode with external interrupt wake-up
• Idle mode

Comparison to the P89C660/662/664 devices

• SPI interface. The P89V660/662/664 devices include an SPI interface that was not present on the P89C660/662/664 devices.
• Dual I²C-bus interfaces. The P89V660/662/664 devices have two I²C-bus interfaces. The P89C660/662/664 devices have one.
• More I/O pins. The P89V660/662/664 devices have an additional four-bit I/O port, Port 4.
• The 6x/12x mode on the P89V660/662/664 devices is programmable and erasable using ISP and IAP as well as parallel programmer mode. The P89C660/662/664 devices could only be switched using parallel programmer mode.
• Smaller block sizes. The smallest block size on the P89C660/662/664 devices was 8 kB. The P89V660/662/664 devices have a page size of 128 B. These small pages can be erased and reprogrammed using IAP function calls making use of the code memory for non-volatile data storage practical. Each page erase is 30 ms or less. The IAP and ISP code in P89V660/662/664 devices support these 128-byte page operations. In addition, the IAP and ISP code uses multiple page erase operations to emulate the erasing of the larger block sizes (8 kB and 16 kB to maintain firmware compatibility).
• Status bit versus Status byte. The P89V660/662/664 devices used a Status byte to control the automatic entry into ISP mode following a reset. On the P89V660/662/664 devices this has changed to a single Status bit. Since the ISP entry was based on the zero/non-zero value of the Status byte this is an almost identical operation on the P89V660/662/664 devices.
• Faster block erase. The erase time for the entire user code memory of the P89V660/662/664 devices is 150 ms.