S08AC: 8-bit Flexis® AC128/96/60/48/32 MCUs
Overview
Features
Features
Internal Clock Generator
- Programmable frequency-locked loop(FLL) generates 8 MHz to 40 MHz
- Provides multiple options for internal and external clock source and in-application clock switching
- Trimmable with temperature and voltage compensation
10-bit Analog-to-Digital Converter
- 10-bit Analog-to-Digital Converter
- 2.5µs, 10-bit single conversion time
Timer with Ten Programmable Channels
- Two 2-channes 16-bit timer systems
- One 6-channel 16-bit timer systems
- Programmable for input, capture, output compare or buffered pulse-width modulator (PWM)
- PWM can be edge or center aligned
Extensive Serial Communications
- Dual asynchronous SCIs
- Flexible 13-bit module-based baud rate generators
- LIN compatible
- Inter-integrated circuit (I2C)
- Up to 100 Kbps
- Supports broadcasting mode and 10-bit addressing
- Synchronous SPI
- Multi-master operation
System Protection
- Selectable low-voltage detect/reset
- COP watchdog timer
- Option to run COP off independent clock source or bus
- Cyclic redundancy check (CRC)
Input/Output
- Up to 56 GPIO pins
- Programmable pull-ups
- High-current drivers
- Controlled rise/fall times minimize noise
On-Chip Debug Interface
- Single-wire background debug mode
- Non-intrusive emulation
- On-chip in-circuit emulator (ICE) debug module containing two comparators and nine trigger modes
- View and change internal registers and memory while running an application
Key Parametrics
-
- Status
- Active
-
- Flash (kB)
- 96
-
- GPIO
- 70
Development Boards
Target Applications
Comparison Table
| S08AW32 |
| S08AW8 |
| S08AC32 |
| S08AC16E |
| S08AW48 |
| S08AC8 |
| S08AW16 |
| S08AW60 |
| S08AC48 |
| S08AC128 |
| S08AC96 |
| S08AC60 |
The EMC performance of an application using this microcontroller is dependent on a number of factors that are outside the control of NXP Semiconductors. These factors include but are not limited to industrial design, mechanical design, printed circuit board design and layout, components, connectors, and cables. NXP Semiconductors is unable to guarantee the EMC performance of any microcontroller in a specific application. Careful consideration must be made when designing any application to ensure the necessary level of EMC. For more information on designing robust EMC systems please refer to application note AN2764.
- Automotive
- Heating Ventilation and Air Conditioning (HVAC)
- Consumer
- Washing Machines
- Refrigerators
- Room Air Conditioning System
- Boiler Heating Control
- Cooking Products
- Dishwashers
- Motor Control
- Brushless DC (BLDC) Motor
- Universal Motor
- Stepper Motor
- 1-Phase AC Induction Motor