MCIMX6ULL-EVK: Evaluation kit for the i.MX 6ULL Applications Processor
Overview
Features
Features
Main Board
Processor
- NXP i.MX6ULL 528 MHz Arm Cortex-A7 core, MCIMX6Y2DVM05AA
Power management
- Discretes
Memory
- 4Gb DDR3L SDRAM, 400 MHz
- 256 MB Quad SPI Flash
- MicroSD connector
- Footprint for eMMC
- Footprint for NAND Flash
Size
- 2.66 inch x 1.27 inch (6.76 cm x 4.24 cm), 4-layer board
Base Board
Display board interface
- LCD expansion port connector
- HDMI connector and footprint for HDMI transmitter
Audio
- Audio codec
- 3.5 mm Stereo Headphone output
- Mono-Microphone input on board
- Left and Right Speaker Out connectors
Connectivity
- One USB 2.0 Micro-B OTG connectors
- One USB 2.0 Standard-A host connectors
- Two Ethernet (10/100T) connectors
- Dual CAN connector
- SD/SDIO connector
Camera
- Parallel camera connector
Sensors
- NXP® MAG3110 eCOMPASS
- NXP FXLS8471Q accelerometer
- Footprint for gyroscope
Debug
- 20-pin standard JTAG connector
- UART to Micro USB connector
Expansion port
- Arduino header
Size
- 5.12 inch x 4.25 inch (13.0 cm x 10.8 cm), 4-layer board
Get Started
Get Started With i.MX 6ULL
Unleash the power of the i.MX 6ULL using the new EVK development tool. This collection of resources will help you get started with the EVK based on i.MX 6ULL running Linux. We recommend you follow these simple steps: Follow the Quick Start Guide below to run the pre-programmed application. DOWNLOAD the latest BSP for i.MX 6 ULL at the provided link and follow the installation instructions.
- Quick Start Guide i.MX 6ULL Evaluation Kit Quick Start GuideBased on i.MX 6ULL Applications Processor
-
6ULL-EVK QSG Provides an overview of the hardware, kit contents, step-by-step instructions for running the out-of-box demo and a jumper settings quick reference table.
- L4.1.15_2.0.1_iMX6ULL
-
USB to UART Bridge VCP Drivers
If needed, the serial to USB drivers
Manufacturing Toolkit
i.MX Manufacturing Toolkit for Linux BSP