Freedom Expansion Board for MPC17533 Dual H-Bridge, Stepper Motor Driver

FRDM-17533EV-EVB
  • Archived
  • This page contains information on a product that is no longer manufactured (discontinued). Specifications and information herein are available for historical reference only.

Roll over image to zoom in

This Freedom evaluation board supports the MPC17533 two-channel, H-Bridge driver for either a single stepper motor or two brushed DC motors. It provides a small, low-power, cost-effective evaluation and development system for quick application prototyping and demonstration of Kinetis® MCU families.

  • Offers an easy-to-use mass-storage device mode flash programmer, virtual serial port and classic programming and run-control capabilities
  • Includes built-in shoot through current protection and undervoltage detector to avoid malfunction
  • Saves cost and space that would otherwise be used implementing a charge pump
  • Efficiently drives many types of micromotors with low power dissipation
  • Processor Expert® component for low voltage H-Bridge products enables rapid embedded application development

Product Details

Supported Devices

Products

No Longer Manufactured

  • MPC17533: Dual H-Bridge, Motor Driver, 2-6.8V, 1.4A, 200kHz

Features

General Specifications

  • Designed for use with FRDM-KL25Z (can be used with FRDM and Arduino®)

Connectivity

  • Screw terminals for motor leads and power connections

Power Management

  • Fuse protected
  • Built in regulator for logic power supply
  • Board power is separate from host CPU power
  • VG terminal for gate drive voltage

User Components

  • General-purpose LED driven from FRDM-KL25Z

Documentation

Quick reference to our documentation types.

Filters

2 documents

Design Resources

Design Files

Filters

1 design file

Software

Filters

2 software files

Note: For better experience, software downloads are recommended on desktop.

Support

What do you need help with?

  • Narrow your search
Search