I3C Switch with Hardware Select and Enable
P3S0200GM Receive alerts
The P3S0200 is ideally suited for the switching of high-speed I3C signals in communication and server applications, such as servers, workstations and notebooks that have limited I3C I/Os. The wide bandwidth (52 MHz) of this switch allows signal to pass with minimum edge and phase distortion. The device multiplexes differential outputs from the I3C controller to one of two corresponding targets with hardware select pin. The switch is bidirectional and offers little or no attenuation of the high-speed signals at the outputs.
Product Details
Features
General Features
- I3C-bus 2:1 or 1:2 mux with selection pin
- Wide supply voltage range from 2.3 V to 3.6 V
- Switch voltage accepts signals up to 5.5 V
- 1.8 V control logic at VCC = 3.6 V
- Low-power mode when OE is HIGH (2 μA maximum)
- 6 Ω (maximum) ON resistance
- 0.1 Ω (typical) ON resistance mismatch between channels
- 6 pF (typical) ON-state capacitance
- High bandwidth (52 MHz typical)
- Latch-up performance exceeds 100 mA per JESD 78B Class II Level A
-
ESD protection:
- HBM JESD22-A114F Class 3 A exceeds 8000 V
- CDM JESD22-C101E exceeds 1000 V
- HBM exceeds 12000 V for I/O to GND protection
- I3C or I2C 2:1 or 1:2 mux with hardware select pin allowing bus voltage up to 5.5 V
- Server DDR5 RDIMM I3C-bus multiplexing
- Specified from -40 °C to +85 °C
Documentation
Quick reference to our documentation types.
4 documents
-
Fact Sheet
P3S0200 Fact Sheet
-
Package Information
plastic, extremely thin quad flat package; no leads; 10 terminals
-
Selector Guide
NXP System Management I2C, I3C and SPI Selector Guide