The PCA9698 provides 40-bit parallel input/output (I/O) port expansion for I²C-bus
applications organized in 5 banks of 8 I/Os. At 5 V supply voltage, the outputs are
capable of sourcing 10 mA and sinking 25 mA with a total package load of 1 A to allow
direct driving of 40 LEDs. Any of the 40 I/O ports can be configured as an input or
The PCA9698 is the first GPIO device in a new Fast-mode Plus (Fm+) family.
Fm+ devices offer higher frequency (up to 1 MHz) and longer, more densely populated bus
operation (up to 4000 pF).
The device is fully configurable: output ports can be
programmed to be totem-pole or open-drain and logic states can change at either the
Acknowledge (bank change) or the Stop Command (global change), each input port can be masked
to prevent it from generating interrupts when its state changes, I/O data logic state can be
inverted when read by the system master.
An open-drain interrupt output pin (INT) allows monitoring of the input pins and is asserted
each time a change occurs in one or several input ports (unless masked).
Output Enable pin (OE) 3-states any I/O selected as output
and can be used as an input signal to blink or dim LEDs (PWM with frequency > 80 Hz
and change duty cycle).
A 'GPIO All Call' command allows to program multiple
Advanced GPIOs at the same time even if they have different I²C-bus addresses. This
allows optimal code programming when more than one device needs to be programmed with
the same instruction or if all outputs need to be turned on or off at the same time (for
example, LED test).
The Device ID, hard coded in the PCA9698, allows the system
master to read manufacturer, part type and revision information.
The SMBus Alert
feature allows the SMBALERT pins of multiple devices with this
feature to be connected together to form a wired-AND signal and to be used in
conjunction with the SMBus Alert Response Address.
The internal Power-On Reset
(POR) or hardware reset pin (RESET) initializes the 40 I/Os as
inputs. Three address select pins configure one of 64 slave addresses.
is available in 56-pin TSSOP and HVQFN packages and is specified over the -40 Cel to +85
Cel industrial temperature range.